Taulman Red T-Glase – 1.75mm

Taulman Red T-Glase is made of FDA approved polymers for direct food contact or containers. T-Glase is a high strength polymer – great for industrial applications. The major advantage of T-Glase to all other polymers, is layer to layer bonding. Industry uses layer settings that are 50% to 80% of the nozzle diameter with excellent results. In addition, Taulman Red T-Glase is a directly printable polymer for glass clear jewelry.

Buy Now

Description

T-Glase (PETT), short for “tough glass” is composed of the strongest of the PETT polymer combinations available.

Features of T-Glase

Strength – Taulman Red T-Glase is very strong, yet different from Taulman nylons as it’s stiff, like PLA and ABS.

Print Temperature – Optimum temperature is about 212C˚ to 224C˚, but will print down to 207C˚ and up to about 245C˚.

FDA approved – Taulman Red T-Glase is specifically made of FDA approved polymers for direct food contact/containers. This includes cups and other liquid storage parts as well as utensils.

Environmental – While t-glase is not biodegradable like PLA, it is a material that’s considered 100% reclaimable. Thus the new “struders” that convert failed prints back to usable line work perfectly with t-glase. If you have a “struder”, you can actually mix in 12% of the total weight in discarded clear water bottles.

Clarity – like 645 nylon, T-Glase’s clarity supports industry’s requirements for non-destructive evaluation of 3D Printed parts.

Shrinkage – Very low shrinkage makes printing large flat surfaces a breeze. And it easily prints to acrylic, glass, Kapton tape and other platforms.

Bridging – Taulman Red T-Glase is very impressive at bridging.

Fumes – There are no odors or fumes when 3D Printing with T-Glase

Bed Surface – Best printed on glass print beds heated from 60C˚ to 80C˚ depending on part size. T-glase also prints easily on glass heated to 45C˚ and using a thin coat of PVA (Elmers Glue All).

NOTE: Store in an air tight container with desiccants or a de-humidifier when not in use. Make sure to dry filament if it has been left in any humidity at all. All nylons will re-absorb humidity from the surrounding air within 18 hours.

 

Taulman Red T-Glase Examples

Additional information

Weight 1 lbs

Reviews

There are no reviews yet.

Be the first to review “Taulman Red T-Glase – 1.75mm”

Your email address will not be published. Required fields are marked *

You may also like…

Title

Go to Top